400kV Cable Test Termination

SXCTT-400 cable test termination (water termination) is for PD and AC test for XLPE cables up to 220kV.

Additional Product Information

Features & Benefits

Casting silicon rubber seal can be made according to cable section, the cover seal grounding part of terminal

Short peeling length, perfect for routine tests

Specified for AC,LI and SI

Seal terminal without any tools

Insulated cable terminal can test Tg △/power factor

Movable type, convenient for test

Change deionized resin on site, because of quick connector, deionized box can move quickly.

4 pieces of water pipes, it is easy to charge and drain.

User controls flowing speed, pressure and operation mode by electric control valve.

Electric sensor inspects temperature, pressure, flowing speed and water conductivity

Main sized emergency switch cut off power

Enhanced glass steel pipe

Sensor send 4-20mA signal to programming unit, control panel show operation mode

 

Applications

SXCTT-400 cable test termination (water termination) is for PD and AC test for XLPE cables up to 220kV.

Cable partial discharge measurement

AC voltage withstand

Impulse test

Dielectric loss measurement

Heat cycle test for cables

Technical Parameters

Terminal: lowered   1660mm(high)×1325mm(wideness)×3350mm(depth)

Terminal raised     3445mm(high)×1325mm(wideness)×3350mm(depth)

Weights:         330kg /single set

Rated Voltage:           400kV r.m.s

Rated Partial Discharge:   <3.0pC (at 350kV)

Rated lighting impulse voltage:    950kV (1~5/50μs)

Pipe for water terminal:

Inner diameter of inner pipe:   180mm

Maximum cable diameter to be tested:  140 mm

Up/down: manually

© 2016-2021 Sanmen Shixuan Electric Co.,Ltd. All Rights Reserved. Site Map | Terms of Use | Terms and Conditions